I just sat my Engineering Junior Cycle exam! This exam was only worth 30% so there was not that much pressure as I already have most of it done. This exam was only 1 hour and 30 minutes which is good because most of my exams were 2 hours so it was a good way to finish my exams. This exam was very easy. There were questions on alloys, logic gates, questions about your project, things the lathe can do. We also had to sketch a holder for a keypad and a base for a lap. I am not good at sketches but I thought my sketches were detailed enough to get more exams. Most questions were fairly easy but I found questions 4 the hardest as there were more parts to the question. I felt very prepared for this exam. I am hoping for a higher merit or merit for the exam!